Question: What methods are used to assign TCP IP parameters to network hosts quizlet?

What methods are used to assign TCP IP parameters to host?

Using DHCP A TCP/IP host uses the DHCP (Dynamic Host Configuration Protocol) to obtain its configuration parameters (IP address, gateway, name servers, and so on) from a DHCP server that contains the configuration parameters of all the hosts on the network.

What service is used to automatically assign TCP IP configuration information to hosts?

DHCP. Dynamic Host Configuration Protocol (DHCP) is a protocol that will automatically assign TCP/IP addressing information to workstations over the network (see IETF draft standard RFC 2131, 2132, and 3397).

Which TCP IP parameters must be defined for the host to be able to communicate with hosts on a remote network?

Parameters which are required when configuring network connections are: IP address, Subnet Mask, Default Gateway, DNS Server and Host Name. The IP address uniquely identifies each computer on the network and computers use it to communicate with each other.

What are the methods of IP addressing?

There are four different types of IP addresses: public, private, static, and dynamic. While the public and private are indicative of the location of the network—private being used inside a network while the public is used outside of a network—static and dynamic indicate permanency.

THIS IS INTERESTING:  How do I switch from hPanel to cPanel?

What are different ways to assign IP?

The IPv4 address for the Ethernet network interface is assigned in several ways using the following modes:

  1. Static IP. The IP address, network mask and default gateway are configured manually in the system configuration file. …
  2. Dynamic Host Configuration Protocol (DHCP) This mode is mostly used. …
  3. AutoIP.

How is IP configuration information assigned automatically?

DHCP – automatic assignment of IP addresses

This is done via DHCP, which stands for Dynamic Host Configuration Protocol. In other words, it is a protocol to automatically hand out configuration to computers and other devices on the network.

How do routing protocols determine the best path?

The best path is selected by a routing protocol based on the value or metric it uses to determine the distance to reach a network. A metric is the quantitative value used to measure the distance to a given network. The best path to a network is the path with the lowest metric.

How do I configure TCP IP?

Configuring TCP/IP on Windows operating systems

  1. Click Start > Settings > Control Panel.
  2. On the control panel, double-click Network and Dial-Up Connections.
  3. Right-click Local Area Connection.
  4. Click Properties. …
  5. Select Internet Protocol (TCP/IP), and then click on Properties.
  6. Select Using the Following IP Address.

How is the TCP IP protocol related to information transfer on the Internet?

TCP/IP specifies how data is exchanged over the internet by providing end-to-end communications that identify how it should be broken into packets, addressed, transmitted, routed and received at the destination. … Each gateway computer on the network checks this IP address to determine where to forward the message.

THIS IS INTERESTING:  How do I monitor apache?